O2 Sensor Enhancers | Hy-Tronics
Module | PWM |  Hydro*Star
Electronics
The Hydro*Star Hy-Tronics is the electronics needed with the use of the
Hydro*Star Generator or system. It can also be used as
electronics for
hydrogen generators
in general. There are many hydrogen generators
that need
PWMs (Pulse wave modulators) to function properly. You can use
this
Hy-tronics module to accomplish this. This along with O2 Sensor
Enhancers
and the incorporation of a water vapor injector such as the
UltraMist can increase your mileage substantially!
Click here to check out the
UltraMist Vapor Injector.

If you have not checked out the Hydro*Star System, please

Click Here
Excellence ... No Doubt About It!

This Unit Controls Your PWMs, Coil, Pump, and Gauge LED's!
This is an excellent replacement for the
Hy-Tronics Module in the "Run Your Car On Water" manual
many people have purchased but, there is one major difference!

OURS WORKS, THEIR'S DID NOT!
Above, is a photo of the Controller's Front Panel!
Many people have purchased the "Run Your
Car On Water
" manual, how to build a
hydrogen generator, and, as I did, found out
that the "
Hy-tronics Module" in this manual
just did not perform as their manual had
suggested!

We've totally re-designed the circuitry and
have added a second enclosure to house the
30 Amp Mosfet Driver Transistors complete,
with cooling fans!  

Our works, their's did not!
Directly above is our "4 Mosfet Driver". It
has been completely tested on generators requiring
up to 45 Amps and it probably will supply 55 Amps!

The tests above were taken with our new 4 Mosfet Driver
hooked up to a cell drawing 53.2 Amps of current! This
picture was taken over an hour after beginning this test!
Warranty
The Hy-tronics Module, which is the Hydro*Star Hy-Tronics of the Hydro*Star System, also
and workmanship only. If you do not connect the
Hydro*Star Hy-Tronics (PWM) as outlined,
you could burn the system up and void your warranty. More information about your warranty
will be delivered with your order.
Click On The "Buy Now" Button Below To Order!

Please Allow Three to Four Weeks For Delivery!

Your investment for the Hy-tonics Module is $600.0 plus shipping and handling. The reason for three "Buy Now" buttons is
due to the different shipping and handling charges.
For United States
Residents Only
For Canada Residents Only
For All Other Countries
Most cars today are computer controlled. These computer controlled engines have O2 (oxygen)
sensors
on the exhaust system to measure the exhaust gases to see if the gases are too lean or rich. If
the gases are too rich, then the computer will cut back on the fuel going to the fuel injection system. If
the gases are too lean, then the computer will dump more gas or fuel into the fuel injection system.
When you place a hydrogen generator, like the
Run Your Car On Water is, then the gases from the
exhaust will read too lean and the computer will want to increase the amount of fuel going into the fuel
injection system. This defeats the purpose of the addition of a hydrogen generator. So, the solution is a
O2 sensor enhancer. This is also known as a EFIE (electronic fuel injection enhancer). To get all the
information on the EFIE (
O2 sensor enhancer) click below.

                                                    Click Here